Фотовспышка Защита от перенапряжения розетки к розетке антенна молния |

---

Coaxial Lightning Surge Arrester N Female to N Female Antenna Lightning Surge Protector

Feature:

1. The coaxial structure lightning arrester grounds the lightning pulse in the antenna to provide more comprehensive lightning protection.
2. The built‑in gas rechargeable arrester can discharge and ground the surge when the surge voltage exceeds the specified level.
3. The device repeats pulse discharge and recovery actions as needed. It hardly needs to be replaced.
4. The installation is simple, if the pulse arrester is broken, it can be easily replaced with a new one.
5. The coaxial structure of the device ensures high frequency, wide bandwidth, low loss and excellent characteristics of vswr.

Specification:

Item Type: Surge Protector

Material: Iron
Frequency Range: DC 2500MHz
VSWR: Less than 1.1
Loss: Less than 0.2dB
Power Support: 200W PEP

Package List:

1x Surge Protector Arrester

1x Instruction

Note:

1. To check or replace the arrester, use one hand to turn the aluminum knob, tilt the device and take it out. When pressing the button, replace the tool with your finger. 2. When using a high antenna tower, use thick wires. Install a coaxial lightning arrester under the antenna and grind the fastener through the turret. In this case, stick tape on the weatherproof fastener. 3. Throung good is very effective in protecting the surge voltage caused by lightning, and cannot prevent the high voltage and current caused by lightning. To avoid lightning strikes, please install the above lightning conductor with thick cable and connect it to the ground rod.

How to use: The coaxial structure of the device ensures high frequency, wide bandwidth, low loss and excellent characteristics of vswr.  1 . When using the coaxial lightning arrester under the eaves, connect it with an antenna cable. When connecting, install a plug (male) at both ends of the antenna cable. 2. Fasten or weld a copper wire with a diameter of 2.5 to 3.2mm, and connect the upper end of the wire to a lightning protection ground buried deep underground. It is recommended to connect the object and the ground as short as possible. 3. Make sure to grind the hood firmly. It is recommended to refer to books on grounding or consult experts in this field. A) Use independent isolation soil. Do not share the ground with the power cord safety ground used to prevent electric shock. b) Make the grounding resistance as small as possible. (c) Make the area of the grounding plate as wide as possible. By burning the copper plate wide, the area of the grounding plate contacting the ground is as large as possible. d) Separate the soil from other soils as much as possible. e) Since the wells are not waterproof, please place them where they will not be directly exposed to rain, or if they can be exposed to water, fix them firmly with waterproof tape.

About feedback

We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
It is impossible to address issues if we do not know about them!